Installation should pay attention to
- Detail
- Parameters
Installation should pay attention to：
Before installation, carefullyclean the installation surface of the adapter sleeve and the withdrawal sleeve,and there should be no sharp corners and burrs. If there are convex parts, theyshould be cleaned in time to avoid mutual wear between the bearing and theshaft, which will affect the assembly. Accuracy, the friction surface passingthrough the shaft should be all coated with butter.
After adapter sleeve andwithdrawal sleeve are finished to the standard, the axial opening is affectedby the gravity of the material and a small amount of material stress. However,when the floating size is smaller than the standard size, should place a supportblock at the opening to control the inner hole size to be larger than thestandard size before assembly. When adapter sleeve and withdrawal sleeve areinitially installed to the predetermined position, the support block at theopening must be removed before the locking assembly can be performed.
Note: Choose the appropriate adapter sleeve according to the bearing. Thereare many types of adapter sleeves on the market, and the prices of differentmodels and brands are also different. If the adapter sleeve needs to bereplaced, must be selected according to the model size and brand of thebearing. The adapter sleeves purchased in this way are suitable for use, andthere will be no problems of wear and tear of the adapter sleeves and stickingto each other.
During installing, unreasonable installation iseasy to cause damage to the nut groove. As shown in the figure below, the punchis also easy to touch the washer, causing the washer to break.
The corresponding hook wrenchshould be used for tightening.
Hook wrench (crescent wrench), optional matching wrench when ordering nuts